【SUNSTAR】Rear Sprocket Duralumin Review
Fits: HONDA CB600F HORNET, HONDA CBF500, HONDA CBF500, HONDA CBF500, HONDA CBF500, HONDA CB600F HORNET, HONDA CB600F HORNET, HONDA CB600F HORNET, HONDA CB600F HORNET, HONDA CB600F HORNET, HONDA CB600F HORNET, HONDA CB600F HORNET, HONDA CBF500, HONDA CB600F HORNET, HONDA SHADOW400, HONDA SHADOW400, HONDA SHADOW400, HONDA CBR600F3, HONDA CBR600F3, HONDA CBR600F3,
It's light!
[How is it used?
YZF-R1 (2CR) I decided to change to Other Brand Product as the OEMSprocket of the company had come due for replacement.
I had a hard time choosing between ISA and SUNSTAR, but I chose this product because of its price and BrandImage.
Was the one you received as per Image?
I felt it when I held it. "Light! It was obviously lighter than the OEM one, so I measured it and it was less than half as shown in the picture.
I was satisfied with the NORMAL run, so I decided to go with the same size as the OEM of 41 guns with Chain size 525.
[Was it difficult to install?
It is relatively easy to replace the Nut and Axle Shaft as they can be removed.
Since there are different size holes with the same pitch, you need to install the one that exactly matches.
I also bought a new lock nut and replaced it. (Part number:90185-10011×Quantity:5pcs. as of February 2022 was 242 yen×5).
How was your experience with it?
After the replacement, I drove around town, but to be honest, I couldn't feel the difference that much.
However, it was very smooth even before the replacement, so I had no complaints at all.
【Review】
When it comes to Sprocket, SUNSTAR is the way to go! I didn't notice much of a difference when riding around town, but it's lightweight, so it should be good, right?
I don't like the color of Champagne gold, so it would be nice if there was a Blacketc. line up in a more subdued color.
Responses
Other reviews
exchange
I bought this for a ZZr250 Rear Sprocketfor replacement, it is lighter than the OEMSprocket and looks better in Gold. It is an applicable product and I was able to install it without any modification. View detail
Stable SUNSTAR
I was not sure about BlackSteel, but I decided that lightness is justice.
I changed from 43T to 42T, but since it is Rear, I don't think it changes anything experientially.
Next time I will change Front as well and see how it goes.
View detail
A little tainted.
Used for Restore of TW200
I bought it to go along with the Front that I also replaced.
Maybe it didn't have to be Duralumin.
Well, I bought it.
The items are clean and trustworthy.
View detail
Rear Sprocket replacement
Changed Front from 14T to 16T and Rear Sprocket from 48T to 46T.
I thought it would be sluggish at the start because the GEAR ratio was quite low, but I don't mind that much.
It is easy to handle for long touring and city driving.
View detail
520Conversion
Conversion520 from 530. It is easier to push and move. View detail