【unicar】Heat Resistant Motor Cycle Cover Half Type Review

It won't dissolve.

The fabric of the Cover is thin and light, but
The heat from the exhaust system did not melt the body cover immediately after stopping the Motorcycle.
It is lightweight, easy to put on and has a Belt to prevent wind-skipping. View detail

thin and light

Even though the fabric of the cover is thin and light, it will not melt from the heat of the exhaust system even if you put the body cover on immediately after stopping the motorcycle. The cover is light and easy to put on and has a windproof with belt. View detail

Monogusa is surprisingly large and durable This is a people and motorcycle friendly Cover

Now Katana is stored indoors, but there are times when you have to put it outdoors

The other day, the Side Stand was too lax and the motorcycle fell over in the parking lot at work and the helip; LeftBlinker was torn in Large, Clutch lever was broken from the root Unable to run
I checked out a few motorcycle shops in the area, but there were no spare Clutch levers available I had to leave my motorcycle at work for four days between order and arrival
I've heard of Prank and parts theft there, and even the Motorcycle itself being stolen Therefore, I was filled with anxiety

This is when the Motorcycle Cover comes in handy
Once you get home, grab your Cover and go back to work, hang up your Cover, lock it up, and All we have to do now is to wish them well for the next four days

This Cover is very well made, it has a 4-ply construction and is thick and non-woven, so it feels good to the touch It's soft and gentle As for the feel, I use it for Corona prevention "Nonwoven Masks It feels just like a "good old-fashioned" bike, so there's no need to worry about damaging your motorcycle

Because the rubber is in the mouth part of the head, you can hook the edge of the mouth on the lower part of the rear wheel and move forward Pull on it and the motorcycle will be Exactly wrapped (20-30 seconds so far.)
In addition, the middle section has a belt with a buckle that passes underneath the motorcycle If you connect them and squeeze the Belt, you won't have to worry about getting caught in the wind, and the Fit feeling will be less than Outclassing (The whole thing should take 40-50 seconds to complete.)

I further wrapped the Wire on the GRU and Dial lock along the Belt Now there will be no Prank or theft as long as the Wire is not cut … and finally It was a relief

I've always had a Motorcycle commute and the Cover gets in the way when I'm in a hurry But this Cover is very easy to hang up and take off It doesn't take long If you have Space at your doorstep, you can take it off on your way out, leave it as it is, and when you get home, you can take it off in a flash Cover & hellip; this ideal habit will be painlessly acquired

The only drawback is that it is bulky when it is folded because it is well made and thick The size is LL, but when you fold it and put it in the attached net, you can make a smallish cushions (Laughs) (Laughs)
Still, I'm using my Tanax Moto fizz "Your Shell Case When you need to hang a cover on the road, you can pack it in I'm going

…After the fall, I survived the 4 days without Prank and now I have The repairs are done I'm relieved

MotorcycleAfter the rainy-weather days, today's Motorcycles are indoors For storage purposes, the Motorcycle Cover is not what I normally use, but Isa I truly realized how much I can rely on it when I'm in a situation like this …
If you don't have one, you should definitely get one View detail

Comfortable

I am using it with DMONSTER 1100 EVO.
I chose 3L which was on the list.
The front side is relaxed on the ground, and the back side is Size about the Freshest on the ground even while wearing the Seat bag.

With unique exhaust pipe, "Insoluble" Area was a tokoru that worried whether it would overlap properly, but the exhaust pipe on the front side was outside the area that did not melt. To this, we are dealing with dropping Towel from Frame.

I think that the rear side also becomes out of the area that does not dissolve in the Up type Exhaust System.

It is easy to handle lightly, but not with LePera, it is a solid Kanji and its Waterproof nature is also high.

As for durability, I do not know yet. View detail

Used in garden of detached houses in apartment complex

Motorcycle is kept in the garden behind the detached houses parking lot.
I thought about buying Bike Cover so that it would not be noticeable from the outside.
Because it is also used for commuting, Exhaust Systemetc. I searched for a usable Cover even though it is hot but I chose this product.
I think Size is perfect in LL.

As impressions I used, I am extremely satisfied that the Exhaust System can be hot even while it is hot.
The hole for Motorcycle lock is also a front wheel - I think that the place where the rear wheel is open is a good point. (I do not use that hole - - - )
Also, there is a place where there is One - touch belt for preventing bumps due to wind.

As MinusPoint, waterproof performance is somewhat inferior or not.
Because it is kept where there is no roof, Motorcycle gets wet with permeation from Cover as it keeps raining.

Because I can not store under the eaves, I am thinking that I want a roof. It is against the bride as it needs to cut the tree in the garden - - - View detail