Internal diameter 14mm -15mm [Product Description] ・1 base x 1 ・2 Guards x 1 ・3 collar 12mm x 1pc. ・4 collar 6mm x 1pc. ・5 Anchor x 1 ・6 Anchor nut x 1 ・7 Slider base x 1pc. ・8 Sliders x 2 ・9 Washers x 2 ・10 Shaft x 1pc. ・11 Cap bolt M6 x 65 x 1 ・12 Cap bolt M6 x 50 x 2 ・13 M6 Washers x 2 ・14 Extra-low head bolt M5 x 6 x 2pcs. ・15 Parallel pins 2 x 8 x 4 ・16 Parallel pins 2 x 10 x 4 ・17 Parallel pins 2 x 15 x 4 ・18 Parallel pins 2 x 18 x 4 ・19 Parallel pins 2 x 20 x 4 ・20 Parallel pins 2 x 22 x 4 ・21 AELLA Etching plate x 2
Full Exclusive Design 4 Handlebar Position(Throttle Angle)Adjustable Type*The following is compared measurement to the STD Parts. 1. Width30mmShort/Height23mm Low/Opening 9mm Front(During Shipment) 2. It is slightly narrowing down 1 to a standard, and opening more distantly to 2 degrees corner depths. 3. It is close to the aperture angle 2-degrees in front on the basis 1 and it is slightly stop. 4. It is close to the most front aperture angle of 6 degrees on the basis of 1, and slightly squeezing it most (at the time of the central clamp part reverse). 4(7)pieces Assembly Type Structure It has been adopted to the chromium molybdenum steel positioning pin. Relaxation of excessive hard feeling and Lightweight reduction by lightening processing. It is possible to repair than bolt single item. OEM Bar End Correspondence It is a switch box positioning drilling already. It does not require cable and hose replacement.
It corresponds to Inner Diameter 16mm-17mm. Used Bolt: Cap M6/L45 Weight (One Side): Approximately 158g Handlebar Interior Support (Brass/Weight): Approximately 59mm Bar End Part: Approximately 32.5mm Quantity: 1 Set of 2pcs.
It corresponds to Inner Diameter 14mm-15mm. Used Bolt: Cap M6/L45 Weight (One Side): Approximately 137g Handlebar Interior Support (Brass/Weight): Approximately 59mm Bar End Part: Approximately 32.5mm Quantity: 1 Set of 2pcs.