ชุดสีมอเตอร์ไซค์

Cheap and Parenthesis good

It is inexpensive, looks good, and is highly satisfactory. ดูรายละเอียด

Position slightly higher on the waist than OEM!

The OEMSeat has a slippery surface, which is good on flat terrain, but when going downhill, it makes your ass gap forward (sweat).
Especially on long descents, this makes it difficult to turn the Curve because you have to maintain your posture with your arms and footpegs…

From this downhill experience, buy here!
The epidermis is coarse and stitched.
My ass is a lot less likely to gap forward.

And the Seat is about an inch or two thicker than the OEM.
The footing might be worse.
Gentle on the ass sounds good!

If you've been riding for a long time and you're thinking of replacing the Seat, you're in for a real treat.
Is this cheap enough for you?
If you want to make your custom look cool and thin, this may not be the right choice for you.
It's a thick seat, so it's not very stylish… ดูรายละเอียด

Cost-effective License Plate Light

I bought it for the ZX-11

It is easy to install as it is tightened to the number of bolts


Wiring is no problem if you connect it with the Bullet Terminal and Coupler Mm

And the light is perfect! It's too bright


You can choose the color of the License Plate Light itself, I chose Gold It was good for the price

License Plate Light is available from various manufacturers, but Isn't the License Plate Light here a pretty good cosmetic? ดูรายละเอียด

fashion-conscious

The CALI Seal, which looks small in the License Plate, will have a dedicated room for you It's all dressed up! More than 60 words on this product is soberingly hard.. ดูรายละเอียด

Design was good for the price as well.

When attaching to MSX 125, I fixed it with 4 Brackets,
The Bracket 1 pc was not able to be installed correctly.
Initially I pulled Cowl and fixed 4 points, but Bracket was Quantity : It resulted in 2 pc breaking.
I reported to Manufacturer and purchased Bracket Only additionally and wore it again, this time, three points (FL, FR, RR) I fixed it, but I was not able to get on with the vibration of Motorcycle, Bracket 1 pc (FL) Break, part of Cowl (Bracket mounting part of RR) It became a condition that it was damaged and I could not make a role as Cowl.
Although it may be awkward because it is a motorcycle with a lot of vibration, I think it is difficult to adapt to MSX 125.
I made RL's Bracket and fixed it at 4 points with chitin and I think that if you take measures against vibration by using RubberWasher etc. on Bolt to fix it, I think that there is a possibility of becoming a machine. ดูรายละเอียด