เครื่องมือวัด

ซื้อสินค้าตามรุ่นรถ

9 รายการ

ความคิดเห็น

There is too much play in making products, which is inconvenient. There is an error of 1 mm from 0 to 40 mm in display of measurement, and it is impossible to accurately measure the oil level.

Since the Head part attached from the beginning can not be replaced, if there is no Space it can not be used. It was a mistake to purchase thinking that the head part attached at the beginning can also be exchanged. At my XR BAJA there is an Engine Starter Motor under the Pilot screw, I thought I'd enter Limit, but the space did not come in without it. Head part is about 32 mm.

Depending on the type of Carburetor, the position of Screw may be downward, and it can not be turned by a normal Driver. So I bought this tool. It is convenient to use even one shot Engine even 2 to 4 shots.

Shared when doing maintenance and restore dozens of people with multiple people in school days
I bought it as a tool of. I think the price has not changed from the past.

I think it is normal to do with a cotton swab, but if it is a cotton swab, it can not be removed,
Cotton Garbage is easy to get out. When the cotton swab is cleaning the cylinder part of Valve seat
I wonder if I can use it.
Because it is a stick of wood, the angle is not right, so it is slightly strict, scrape it like a Taper
Even so it collapses so so it is not good.

In that respect Seat cleaner is sticking an exquisite line. Hardness and accuracy
Good. Large resistance will not be beautiful with a single shot, but if you glide gently, it will be beautiful
Become. There are still some polishing effects, but Seat that got hurt
I can not return it.. Note this point.
(I will glitter it by attaching a fine compound to the original.. )

I think that Material is oil resistant Nylon, but it becomes scratch and stepped wear
It is hard..
Just because it can not be used forever, exchange is necessary if you use it hundreds of times,
At that time I can not buy it at Rose because it hurts. Because it is expensive, I buy it every time in Set
It is tough..
Well, since it is possible to use it without any wear and scratches, if it is individual Youth
It may not be necessary to buy Spare.

Be [ Final edition / even if a GSX1100S-KATANA Final edition does not remove a carburetor / of
Drain portion to a Main jet / exchangeable ].
-- since the up-and-down Space is however restricted -- a Slotted screwdriver
-- Difficulty ...
-- at such time, if Colet has, exchange of a Jet can be performed simply.

although the Size of a Jet and the Size of a Wrench are cinch, the portion (black portion of a photograph) which pinches and turns is only needed [ which has put the Rubber ]. The metal of the
Wrench and a Rubber are not being fixed at all. Probably, in a Plastic, grazing will be dreadful, since it is a portion which requires the
> Gasoline easily. If a Rubber is removed, power will not enter, but even if it pickles a Rubber, it slides.
It was thought that he wanted a device to a slight degree.

If it is Jet exchange of a carburetor and there is this, it is easy at a work plane. It has gone by the makeshift by other tools, and in the middle of work, if too useless, it is not necessary to carry out by removing the whole main part. In the case of purchase, he does not forget the check of the Space into which the Wrench and the hand can go.